Operating Instructions
Specifications
Temperature taking
Place the
Probe Cover
1. Place the probe cover on the probe cover fixer(inside of
the storage box). Make sure to place the “
Adhesive Side
”
of probe cover “
Upward
.”
Align the probe with the center of the probe cover.
2. Insert the probe into the probe cover fixer (in the storage
box) until you feel a “click”. That means the probe cover
has been connected firmly.
1. Proper installation of the probe cover and using the
specific probe cover ensure accurate measurements.
2.
Warning: Choking from swallowing small parts and
batteries by children or pets is possible, please keep
small parts and batteries at places where children and
pets can’t reach.
If the probe cover did not install well,
will flash on the
LCD screen and can’t take the ear temperature (will hear 4
beep sounds without reading shown on the LCD when
measuring).
Please check the setting of the probe cover again.
Power On
①
②
①
Press
“ON/MEM” button (on the left side)
②
See the
icon on the LCD and hear two beep sounds
Taking Ear
Temperature
Gently pull the ear back to straighten the ear canal and
snugly position the probe into the ear canal, aiming towards
the membrane of the eardrum to obtain an accurate reading.
<For children under 2 years old>
Pull the ear straight back.
<For children over 2 years old and adults>
Pull the ear straight up and back.
Measuring
Press “Scan” button
(on the right side)
Press the “Scan” button for 1 second until you hear a long
beep sound. The measurement is completed. You can read
the result from LCD. After two short beeps are heard, the
icon stops flashing to be ready for next measurement.
Fever Indication :
If the thermometer detects a body temperature
≥
37.5°C (99.5°F), three short beep sound will follow one long
beep sound to warn the user for potential fever.
Power Off
Automatically shut down after 1 minute pending to extend battery life.
Attentions
a. If there is any temperature difference between the places where the device is stored and where you are going to measure,
subject and the device should stay in the same room for at least 15 minutes before measurement.
b.
Before the measurement, the subject should stay in a stable environment for 5mins and avoid the exercise, bath for
30mins.
c. It is recommended that you measure the same ear for 3 times. If the 3 measurements are different, select the highest temp..
d.
The thermometer has been designed for home use. It’s not meant to replace a visit to the doctor. Please also remember to
compare the measurement result to your regular body temp..
Please consult with doctor if you have health concerns.
Other Functions
Last Reading
After getting a new body temperature, the last reading will be shown on the screen (at top right corner)
with the
icon.
Memory
Locations
(25 sets)
When power on, press the “ON/MEM” button to see the temperature records with
icon.
°C / °F Switch
To change the LCD from °C to °F :
In “
Power Off
” mode, press and hold the “SCAN” button, then press the “ON/MEM” button for 3
seconds, icon “
°C
” will be switched to icon “
°F
”. You can also use the same process to change the
LCD display from
°F
to
°C
.
Temperature measurement range: 34~42.2°C (93.2~108°F)
Operating temperature range: 10~40°C (50~104°F), 15%~85% RH
Storage temperature range: It should be stored at room temperature between -20~+50°C , RH
≤
85%
Transportation temperature shall be less than 70°C, RH
≤
95%
Atmospheric pressure: 800~1013 hPa
Comply with ASTM E1965-98, EN ISO 80601-2-56, IEC/EN60601-1-2(EMC), IEC/EN60601-1(Safety) standards, ISO10993, RoHS.
Accuracy: ±0.2°C (0.4°F) within 35~42°C (95~107.6°F), ±0.3°C (0.5°F) for other range.
Fever indication & Memory, °C / °F Switch function
Battery: one lithium cell battery (CR2032 *1pcs)
Battery life: around 3,000 continuous readings.
Expected Service Life: 4 years
This thermometer
is an adjusted mode thermometer that
converts the ear temperature to display its “oral equivalent.”
(according to the result of the clinical evaluation to get the offset value)
E:LED Backlight (optional), LED Backlight will be automatically turned on after measurement, and automatically turned off after 5 seconds.
Enclosure Rating: IP22
Dimensions: 120.4 x 37.8 x 40.3 mm
Weight: 57.7 grams including battery
The device should not submerge into any liquids and expose it to direct moisture.
There is no gender and age limitation for using infrared thermometer.
This is not an AP
or APG product.
TH709L(E) Infrared Ear Thermometer Operating Instructions
Intended use:
The ear thermometer is electronic thermometer using an infrared detector (thermopile detector) to detect body temperature from ear
canal in people of all ages.
Intended operator:
Have eight years of education,
no maximum.
＞
2 years
0 – 2 years
Summary of Contents for TH709L
Page 4: ......
