Radiant BH15UT, Installation, Operation & Service Manual

Page: 49 / 82

SECTION 10: O
PTIONAL
H
EATER
A
CCESSORIES
43
10.2 U-Tube Cover Installation
The package contains t w o reflector joint pieces (P/N 02750901), one 8’ reflector and 18 x #8 sheet metal scre w s.
Install the U-t u be co v er u sing the follo w ing proced u re.
Step 10.2.1
C u t the 8’ reflector in half to be u sed on both sides to
co v er the U-t u be.
Step 10.2.2
Flatten 4’ reflector edge w here joint piece matches. P u t a
mark on the 4’ reflector, directly o v er the t u be center.
Center the accessory joint piece on the mark and scribe
its conto
u r on the reflector. Scribe the location of the
mo u nting holes.
Step 10.2.3
C u t a w ay the reflector to clear the t u be, lea v ing abo u t 1”
of material inside the scribed conto u r to attach the
accessory joint. Drill or p u nch six 3 mm diameter holes in
reflector in the positions sho w n belo w .
Step 10.2.4
Use six #8 sheet metal scre w s to attach the joint piece.
Repeat Step 10.2.1 through Step 10.2.4 to attach the reflector joint piece on the other reflector.
Step 10.2.5
The o v erlap of both reflector joint pieces is attached w ith six #8 sheet metal scre w s.
4' Reflector
Section
Reflector
Joint
Flatten
Edge
250 mm
maximum
Scribe
Contour
Cut away contour
with tin snips.
Punch/Drill six
3 mm holes
Reflector
End Cap
(Do not remove
cut out)
Attach Reflector
Joint with six #
8
sheet metal screws.
Secure overlap
with six #8
sheet metal screws.
4' Reflector Sections