PAGE 9
troubleshooting
•
•
•
•
•
•
•
•
•
•
Check if the power cable is connected.
Ensure that the power cable has been
switched on at the power plug. Make sure
the red light at the power plug is lit.
Turn on ignition.
The detector could have received a false
alert signal from a motion sensor. Lockout
the known false alert locations by pressing
the middle button during the alert.
GPS detection has been turned off in the
menu. Turn GPS detection on.
The location is not yet stored in the
database. Check if a database update is
available.
The vehicle in front of you is equipped
with Blind Spot Mirror or Lane Assist
feature. Turn on the K band filter.
Speed info traffic sensors are in place
along your road. Turn on the Traffic Sensor
Rejection filter (TSR) in the menu.
Your vehicle may be equipped with a
metal coated windshield that prevents the
reception of radio waves.
Check with your
local dealer.
The speed limit setting in the menu has
been set above normal traveling speed.
Set a lower speed or turn off speed limit
setting.
The location used to have a speed or red
light camera but it was disassembled.
The camera is located on the other side of
the road in the opposite travel direction.
The camera is not a speed or red light
camera.
Check if the power cable is connected and
turned on.
Check if the display is set to “dark” mode.
The dectector will not turn on.
The unit suddenly alerts at high in-
tensity while driving on the Interstate
although there is no police in sight.
Radenso Pro M never alerts to radar
or alarm turns on after passing the
radar source.
The detector alerts to a speed camera
or red light camera but no camera can
be found.
The display will not turn on.
•
•
•
•
•
•
•
•
•
•
The alert volume is turned down. Increase
the volume.
The officer isn’t operating radar equipment.
One or more radar bands have been
deactivated. Check in the menu if all radar
bands are turned on.
You may have activated a speed limit in
the menu and you were traveling below
the set speed limit.
You activated Speed Meter Mode which
disables the radar antenna.
The detector alerts visually but there
are no voice or audio alerts.
The detector alerts visually but there
are no voice or audio alerts.
The windshield mount does not
adhere to the windshield.
The detector alerts to a signal but no
police radar trap can be located.
The unit did not alert to a red light or
speed camera.
The detector starts alerting with low
intensity following another vehicle.
• Clean the suction cups and the windshield.
