PAGE 8
Setting AutoCity Speed
GPS Lockouts
settings
The AutoCity driving mode allows the
setting of minimum alert detection speed
for signal suppression and signal filtering
resulting in significantly reduced false alerts.
Select AutoCity in setting mode.
Setting AutoCity speed (this feature is only
selectable if the Pro M is in AutoCity mode):
tapping the middle button lets you select
the speed for editing.
The left speed setting indicates the speed
below which the radar reception of the
detector will be disabled. No signals from
police radar or false signals will be reported.
The recommended setting is 20 mph.
The right speed setting indicates the speed
below which the detector will detect alerts
in City mode with reduced radar sensitivity.
The recommended setting is 35 mph.
The + / - buttons on the right side of the
detector will change the specific setting.
Setting the City and AutoCity sensitivity
(this feature is only selectable if the Pro M is
in City or AutoCity mode): by means of the
middle button
you can select the radar band
for editing.
To change the sensitivity of signal reception
use the +/- button on the right side of the
unit. The level of signal suppression can be
selected between 0-9. The display numbers
indicate the sensitivity reduction in the
different radar bands.
The detector lets you mark known false
alert areas so that you will not receive audio
alerts in the future at the marked location.
The detector stores the GPS coordinates
and radar band, frequency, and signal
strength and compares it each time the
signal is received. If the received signal at
the lockout location from the saved signal
in terms of frequency or signal strength, the
detector automatically unmutes and you will
be alerted by audio again.
The display will show the band and signal
strength and a small “L” icon in front of the
radar band letter indicates that the area is
locked out. You can either ignore the alert or
delete the saved lockout.
To set a GPS lockout press the middle
button during an alert for two seconds. The
detector will state “lockout started” and will
complete the process by stating “false alert
area added.”
To manually unlock the detector press the
middle button for 2 seconds in a locked out
area. You can also delete all lockouts in the
menu.
