PAGE 4
The Radenso Pro M windshield mount
allows a rm and secure installation of the
radar detector at the windshield. Locate
an area at the windshield that enables an
unobtrusive installation with a clear view to
the road ahead. For best results, adhere the
detector as high as you can.
Installation
installation guide
To start using your Radenso Pro M radar
detector, follow these easy steps:
Slide the windshield mounting bracket
into the QuickMount slot at the front of
the radar detector.
Plug the small end of the power cable into
the power jack on the Radenso Pro M left
side and connect the large plug with the
12V power socket in your car.
Press the red button at the large end of
the power cable (at the 12V socket) to
turn the power cable on. The button will
light up to indicate that the power is on.
Press the power button for 2 seconds to
turn on the Radenso Pro M. The unit will
power up with the start up sequence.
After a few seconds, the Radenso Pro M
will notify you that the GPS is connected
with a solid “GPS” on the display.
Adjust the volume level by pressing the
volume buttons located on the right side
of the unit.
Place the small side of the suction cups
into the large hole of the bracket. Slide
the suction cup into the small hole to se-
cure them. Push the rubber damper in the
small hole in the middle of the bracket.
Attach the windshield mount to the
desired area of the windshield. Make sure
it is in a level position, parallel to the road
ahead. To adjust the angle if necessary,
gently push or pull the bracket to bend
it.
Do not use the detector to bend the
bracket.
Insert the windshield mount into the
slot at the front of the detector until
it is locked in position. For rm and se-
cure adhesion to the windshield, clean
the windshield and suction cups before
installing.
Plug the small end of the power cable into
the detector on the left side and the large
end into your vehicle’s 12V ACC socket.
To remove your Radenso Pro M from the
windshield, press the release button on
the top of the unit and slide the unit o
the mount.
Quick Start Up Guide
Your Radenso Pro M is now ready to go.
If you want to change any of the default
settings of your unit, please refer to pages
6-7.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
