4
Subjec
t t
o t
echnical modifica
tions
, misprin
ts and err
ors
. Illustr
ations not binding
.
Installation
D
(5.1)
(6)
6
Mounting the roller shutter casing
7.
(5.2)
◆
Slide the ties or the rigid shaft connectors
(6)
onto the upper-most slat of
the roller shutter casing
(14)
.
◆
Place a tie or rigid shaft connector
(6)
every 40 cm into the rectangular
holes of the winding shaft
(5.2)
and the telescopic shaft
(5.1)
.
(14)
Electrical commissioning/settings
8.
Follow the information in the enclosed operating manual for the tubular
motor.
Installing the tubular motor in the bearings (12) / (1)
6.
(10)
(11)
(12)
(5.1)
(1)
(2)
◆
Click drive bearing
Press the drive head (11) into the click drive bearing (12).
The set button
(10)
must be easily accessible. This also applies to the
adjustment screws for setting the end points on mechanical tubular motors.
◆
Counter bearing
Press the counter bearing (1) onto the other side of the telescopic
shaft (5.1) with the fitted ball bearing (2) from above.
◆
Finally, fix both winding shafts (5.1 and 5.2) with the enclosed
flat-head screws (16).
5
STOP
Click drive bearing
Counter bearing
(16)
Warranty terms and conditions
Information about the warranty conditions of our products can be found on
our homepage.
(16)
(5.2)
RADEMACHER
Geräte-Elektronik GmbH
Buschkamp 7
46414 Rhede (Germany)
Simplified EU declaration of conformity
RADEMACHER Geräte-Elektronik GmbH hereby declares that the radio tubular
motors in the RolloTube S-line DuoFern series comply with the Directives
2006/42/EC (Machinery Directive)
and
2014/53/EU (Radio Equipment
Directive)
.
Please observe the information in the enclosed operating manual for the
respective tubular motor.
RADEMACHER Geräte-Elektronik GmbH hereby declares that the tubular
motors in the RolloTube M-line / RolloTube Basic series comply with the
Directives
2006/42/EC (Machinery Directive)
and
2014/30/EU (EMC
Directive)
.
The full text of the EU declaration of conformity is included with the product
and is kept on file by the manufacturer.
WARNING!
WARNING!
Risk of short-circuit resulting from water in the event of improper
cabling.
◆
Never lay the motor cable
(13)
vertically upwards otherwise water may
collect on the cable and run into the motor, leading to damage.
◆
Lay the cable in a loop. The loop will cause any water on the cable to collect
at the lowest point, from where it can drain off.
i
EN
