2
EN
These instructions...
i
...give you a brief description of the installation of the RolloTube Automation
Set.
These instructions do not replace the enclosed manual for the
tubular motor.
Before you begin, please read these instructions through completely and
follow all the safety instructions.
Damage resulting from non-compliance with these instructions and the safety
instructions will void the warranty. We assume no liability for any consequential
damage.
There is a risk of fatal injury from electric shock when working on all
electrical systems.
◆
The electrical connection for the tubular motor and all work on the electrical
systems may only be undertaken by an authorised electrician in accordance
with the connection diagrams in the original manual for the enclosed tubular
motor.
◆
Carry out all installation and connection work only when the product is
disconnected from the mains power.
There is a risk of fatal injury in the event of failure to observe these
instructions!
Observe the regulations for installing products in damp rooms.
◆
Observe DIN VDE 0100, parts 701 and 702 in particular when installing the
product in damp rooms. These regulations contain mandatory protective
measures.
Installation
ATTENTION!
Never knock the motor (8) into the
winding shaft (5.2) with force.
Doing so will cause serious damage.
ATTENTION!
Never drill in the area of the drive or
insert screws in order to secure the
roller shutter.
Removing the old roller shutter mechanism
◆
Open the roller shutter box.
◆
Close the roller shutter completely and release the roller shutter casing
from the winding shaft.
◆
Then remove the existing belt winder and winding belt and close the belt
inlet opening in the roller shutter box.
CAUTION!
There is a risk of injury from the pre-tensioned spring in the old belt
winder.
Hold the spring unit firmly when loosening the belt and allow it to recoil
slowly until the spring unit has completely unwound.
1.
◆
Remove the winding shaft and all bearings.
(14)
1
(1)
(2)
(4)
(6)
(5.2)
(7)
(8)
(9)
(11)
(12)
(3)
(10)
(5.1)
(1)
Counter bearing
(2)
Ball bearing
(3)
Axle pin on the roller capsule
(4)
Roller capsule
(5.1)
Telescopic shaft
(5.2)
Winding shaft
(6)
Ties or rigid shaft connectors
(7)
Catch
(8)
Tubular motor
(9)
Adapter
(10)
Set button or 2 adjustment
screws
(11)
Drive head
(12)
Click drive bearing
(13) *
Motor cable with/without
connector, see page 1
(14)
Roller shutter casing
(13)
*
i
Mark the position of the centre of the old
bearings so that you can install the new bearings
and the winding shaft horizontally in the same
position.
