14
Installation: Rada Exact-3
(Refer to Figure 5)
1.
When unpacked, the inlet elbows are positioned to accept falling supplies.
Should the installation require rising or rear-fed supplies then the elbows will
need adjusting.
(a) Loosen each elbow grub screw using the 2.5 mm A/F hexagonal wrench
(supplied)
(b) Pull the elbow away from the body and refit in the desired position.
(c) Tighten the grub screw.
3.
Mount the backplate securely to wall surface (with the grub screws pointing
downwards) using wall screws/plugs provided.
4.
Install the supply pipework to the respective inlets.
Important!
Flush through the hot and cold supplies thoroughly before connection to
shower control. Failure to do so may result in reduced performance and/or product
damage.
5.
Refit body onto backplate and tighten the grub screws.
6.
Connect inlet pipework, checking that the hot and cold supplies have been piped
to the correct inlets.
(a) For 15 mm compression pipework inlet (or outlet) connections: Use
compression nuts and olives supplied.
(b) For 1/2" BSP union inlet (or outlet) connections: Use flat-faced inserts
supplied, press in firmly.
7.
Connect outlet shower hose or rigid outlet pipework. Check all connections are
watertight. Refer to
COMMISSIONING
.
2.
Where rear-fed supplies are required, pipe concealing plates are provided which
recess into the tiling for a neater finish.
Installation: Rada Exact-3 z
(Refer to Figure 6)
Note!
Rada Offset connectors and offset Pipe concealing plates are not supplied with
this shower control, but are available separately as optional accessories. A backplate
is not required for this installation.
1.
Check that hot and cold supplies are piped to the correct inlet positions.
7.
If the shower control body has already been installed, restore the hot and cold
supplies and check for any leaks.
8.
Align and refit the body shroud and temperature knob assembly so that the
markings will be visible to the user.
9.
The maximum temperature may now need resetting; check, and if necessary refer
to
COMMISSIONING
.