Type
List box {Wired; Wireless}, default = "Wireless"
Type of network interface and also the type of link status evaluation. “Wired” link status is evaluated
by checking the limit of received Hello packets – if not met, the link is considered down. “Wireless”
link is status is evaluated using ETX criteria – each lost Hello packet gradually decreases the link
metric.
Rx cost
Number {1 – 65534}, default = 128
The cost of using this interface to receive packet from a neighbor. It is added to BABEL path metric.
Hello limit
Number {1 – 16}, default = 12
For “Wired” interface only: limit of received Hello packets from the 16 expected; if not met, the link
is considered down.
Hello interval
Number {0.1 – 327.0}, default = 4.0
Interval (in seconds) of sending Hello packets.
Update interval multiplier
Number {2 – 30}, default = 4
Interval of sending the routing table update packets – to share the network topology information
across the BABEL network. The update interval is calculated as a multiplication of this parameter
and
Hello interval
. The maximum length of the update interval (after the multiplication) is 655
seconds.
Advertised next hop
IP address, default = 0.0.0.0
This is the Next hop address which is announced to neighbors to be routed over this interface.
Should this interface serve more IP addresses, this parameter enables selection of which of the
addresses should be used for this station in the network neighbors routing tables.
Note
Informational note.
7.2.2.4. Static rules
Pre-defined static routing rules to be exported over the BABEL protocol. Maximum number of rules is
256.
Active
List box {On; Off}, default = "On"
81
© RACOM s.r.o. – M!DGE3 Cellular Router
Settings
