910115
Loading Arm
Phone: (262) 637-9681
Email:
3.2023 Rev 2.1
Page
12
of
23
Proper Positioning on the Rail
Proper Positioning on the Rail
7. Position the control valve into the required
position and pump the valve to position the rail
as needed. (Arrow F.)
If operating the loading arm, continue pumping
until the pressure gauge reaches the force
required for measuring the rail movement.
Removing Arm
1. To remove the arm from the rail, open the clamping ends.
If the rail was pulled, extend the arm until the clamp ends will open freely.
2. Retract the arm to the fully retracted position.
3. Close the end clamps.
4. Insert the pins to prevent them from being lost.
Assist Arm
1. Position the assist arm between the rails.
2. Open the clamping end and set it over the fixed rail.
3. Close the clamp and pin it in place. Make sure the arm is full retracted.
4. Remove the shoe from the end of the arm and position it under the rail.
5. It may be necessary to crib out under the rail if there is not enough room for the shoe.
6. Extend the arm until a set of holes in the arm align with a set of holes in the shoe.
7. Insert the connector pin. (See images below for proper position on the rail.)
