race result AG
Joseph-von-Fraunhofer-Straße 11, 76327 Pfinztal
Germany
+49 (721) 961 409 01
On the display push
Feed,
or
manual feed forward,
and push the liner in to the slit
below the programming antenna until the rollers catch the plastic liner and pull it
through. The machine will keep feeding forward until the first transponder is
positioned over the progamming antenna.
Once finished you can tear off the excess liner by using the serrated cutter on the
lower slit, you should cut the liner here with a transponder still in place as the excess
liner is required to feed in to the system at the next start-up.
On the display select
Switch Mode
and then press
manual feed reverse
to feed the
liner back out of the lower section, if the liner was not cut then it may require multiple
presses to fully remove.
The transponders can now be pulled out from the upper secction, the roll removed
and the mounting arm returned to it's transport position. To power down the unit
simply remove the power supply.
Barcode Scanner Configuration
When using the barcode scanner for the first time it is necessary to scan the included
QR code in order to set the scanner's configuration to correctly work with Chip2Go
machines / barcodes. This should be done once for each individual barcode
scanner.
The QR code is attached below and should be printed out and scanned.
Transponder Number Entry
Touchscreen Keypad (Single Number)
Using the built-in touchscreen display you can program the machine to encode either
an individual number or a series of numbers counting up or down from a starting
number.
When the system is first turned on it will display the number keypad, simply type your
desired chip number and hit enter, the transponder will be encoded to that number
and the number on the screen will automatically increase by one.
To return to this mode press STOP from count up/ count down, or BACK from the
mode selection screen.
Count Up / Count Down
The system can continuously encode chips in a series counting up or down from a
number, to do this first enter the desired starting number on the touchscreen
keypad then press
SWITCH MODE
and select either
n count up
or
n count
down
from the mode selection screen depending on your requirement.
