- 37 -
O
PERATOR
'
S
MANUAL
KORMORAN SF 180 / SF HA 180
9901.00.07EN04SF - 02/2017
6XEMHFWWRWHFKQLFDOPRGL¿FDWLRQV
9.2 First
pass
)RUWKH¿UVWSDVVDQGIRULPSOHPHQWV¿WWHGZLWKDK\GUDXOLFRIIVHW
adjustment cylinder, open to the offset to the maximum position.
For implements with manual offset adjustment, the opening must
be adjusted according to the internal width between the rear
tyres.
2
1
Legend
1 Offset
cylinder
2 Maximum
opening
the tractor is not in the furrow. This may change certain settings,
LQFOXGLQJWKHWLOWGHSWK
To preserve the slides, perform adjustments with the implement
set down on the ground.
9.2.1 Ground
work
ʈ
Drive forwards slowly and lower the implement for a gradual
entry of the bodies into the soil.
9.2.2
Working depth adjustment
The working depth is controlled by:
ʈ
The height of the tractor's hydraulic lifting mechanism for the
front of the implement.
ʈ
The height of the wheel for the rear of the implement.
7UDFWRUOLIWKHLJKWDGMXVWPHQW)RUWKH¿UVWSDVVDGMXVWWKHOLIWLQJ
height of the tractor to avoid the creation of an excessive ridge by
the 1st mouldboard.
Setting the tractor draught control system
Set the tractor draught control to minimum sensitivity. The
working depth of the 1st plough body will be constant. Once
adjustment is completed, increase the sensitivity to optimise the
tractor's grip.
IMPORTANT:
Under adverse conditions (sodden ground, tractor
power limit, etc.) it is not possible to work with the
draught control set to minimum sensitivity. In this
case, account should be taken of lifting mechanism
reactions to estimate the average depth..
Wheel height adjustment
7KHKHLJKWRIWKHZKHHOFDQEHDGMXVWHGDWWKH¿UVWSDVV
&KHFNLQJDQGRUD¿QDODGMXVWPHQWZLOOEHPDGHGXULQJ
subsequent passes.
2
1
3
Legend
1 End
stop
2
Depth adjustment stop screw
3 Cylinder
:KHQZRUNLQJWKHVFUHZLVWRXFKLQJWKHZKHHOVXSSRUWHQG
VWRS
ʈ
To increase the working depth:
-
/RRVHQWKHVFUHZWROHQJWKHQWKHWUDYHORIWKHOLIWLQJ
F\OLQGHUDQGORZHUWKHIUDPH
ʈ
To reduce the working depth:
-
7LJKWHQWKHVFUHZWROLPLWWKHWUDYHORIWKHOLIWLQJF\OLQGHU
and thus the working depth.
2
1
Legend
1 Clamping
screw
2 Adjustment
hole
In the event that the travel of the depth stop or the cylinder is
LQVXI¿FLHQWPRGLI\WKHKHLJKWRIWKHIUDPHE\SODFLQJWKHVFUHZ
LQRQHRIWKHWKUHHSRVLWLRQV
• To reduce the working depth (stops in the fully screwed
SRVLWLRQSODFHWKHVFUHZLQWKHWRSKROH
• To increase the working depth (stops in the fully unscrewed
SRVLWLRQSODFHWKHVFUHZLQWKHWRSKROH
