INSTRUCTIONS
SHARK
®
INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer to
wiring directions.
2. Is the fixture grounded properly?
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough to touch.
Do not clean or maintain while fixture is energized.
1. Lens should be washed in a solution of warm water and
any mild, non-abrasive household detergent, rinsed with
clean water and wiped dry.
WARNING: Polycarbonate is affected by cleaning agents
or other liquids containing partial solvents such as
low molecular weight aldehydes and ethers, ketones,
esters, aromatic hydrocarbons and perchlorinated
hydrocarbons. In addition, chemical attack ranging from
partial to complete destruction of polycarbonate occurs
in contact with alkalines, alkali salts, amines and high
zone concentrations. Please go to rablighting.com for a
detailed list of damaging chemicals.
2. Do not open fixture to clean the LED. Do not touch the LED.
PINK (or GRAY)
LIGHT
FIXTURE
Vaux 12V
YELLOW
GROUND
GROUND
( - ) DIM V
( + ) DIM V
COMMON
LINE
BLACK
WHITE
PURPLE
Fig:10
0-10V DIMMABLE WIRING
Universal voltage driver permits operation at 120V thru 277V,
50 or 60 Hz. Units ordered with
(/480V)
suffix are 480V, 50Hz or
60Hz. For 0-10V Dimming follow the wiring directions as shown
in Fig. 10.
1. Connect the black fixture lead to the
LINE
supply lead.
2. Connect the white fixture lead to the
COMMON
supply
lead.
3. Connect the
GROUND
wire from fixture to supply ground.
Do
NOT
connect the
GROUND
of the dimming fixture to
the output.
4. Connect the purple fixture lead to the (V+) DIM lead.
5. Connect the pink
(or gray)
fixture lead to the (V-) DIM lead.
6. Cap the yellow fixture lead, if present. Do NOT connect.
ANGLE SURFACE MOUNTING
Angle Surface Mounting Brackets Fig. 8
(
ANGSHARK-G2 ordered separately)
1. Use appropriate mounting hardware
(not supplied)
to secure
the
Angle Bracket
(ANGSHARK-G2) (2)
to mounting surface as
shown in Fig. 8.
2. Recommended
Angle Bracket
distance center to center is
12 7/8” for SHARK 2ft and 36 13/16” for SHARK 4ft.
3. Secure
Surface Mounting Brackets
(2)
to
Angle Bracket
(2)
with
Screws
provided.
4. Snap
Housing
on
Surface Mounting Brackets
(2)
as shown in
Fig. 9
.
Fig: 8
Fig: 9
Angle
Bracket
(2)
Housing
Screw
Surface
Mounting
Brakets
Mounting
Surface
