Rough-in Section
(Bottom of the
Rough-in Section
to be flush with
finished ceiling)
Butterfly Brackets
Female Connector
Knock Out
Clip
Junction Box
Fig. 1
Butterfly
Bracket
Wing Nut
Fig. 2
Nailer Bar Slot
ROUGH-IN MOUNTING
The fixture is suitable only for INDOOR RECESSED CEILING
application. Charging indicator test switch should be visible
and accessible and be located maximum 2 feet from the
fixture. Access above the ceiling is necessary.
1. Nailer bars are provided for use with wood joist
installations. Insert through
Nailer Bar Slots
in
Butterfly Brackets
and secure accordingly. C-Channels
are optionally available, consult factory. Consult local
building codes for final support of fixture.
2. Remove appropriate
Knock out
on Junction box. Press
Clip
to open the
Junction Box
.
3. Feed the supply wires through
Knock Out
hole and
connect to the driver. See wiring section for details.
Connect Inverter Plug only after supply wiring is
complete (see wiring instructions).
4. The fixture can be adjusted to different heights above
the ceiling surface. For height adjustment, loosen the
Wing Nut
and slide the
Butterfly Bracket.
If necessary
remove the
Wing Nut
and insert screw in different hole
provided on the
Butterfly Bracket
. (Fig: 2)
5. Adjust both the
Butterfly Brackets
such that the frame
of
Rough-In Section
is flush with the finished ceiling
surface. Tighten the
Wing nuts
.
6. Install the
Switch Plate
(along with the charging
indicator) in a suitable
Junction Box (by others)
. It
should be located maximum 2 feet from the fixture.
Rough-in
Section
Trim Module
Female Connector
Torsion Spring
Trim Ring
Male
Connector
TRIM MODULE MOUNTING
1. Pull
Female Connector
conduit through frame opening.
Raise
Trim Module
towards opening and connect to
Male Connector
conduit.
2. Press
Torsion Springs
inward and slide
Trim Module
info frame opening. Release both springs into opening
together.
Trim Ring
should be flush to ceiling.
3. For the Wallwash Model, orient the fixture such that the
reflector is in correct orientation. Look for ‘Towards the
Wall’ label on the fixture.
ND4R/ ND4S
LED EMERGENCY BATTERY BACK UP INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
Fig. 3
