TEX150-LCD/S
9 / 24
User Manual
Rev. 1.0- 09/07/04
The bar to the right of “Mod” indicates the modulation progress in real time; the broken
bar indicates the maximum nominal modulation of 75 kHz (100%).
To
vary the set power level
, select the line pertaining to power with the DOWN key
and keep the ENTER key pressed until you have entered “modify” mode.
The screen that will appear in “modify” mode is similar to the one shown below:
The lower line shows the instantaneous power reading (in this example 97W), while
the bar indicates the set level. To increase the level, press the RIGHT/DOWN key, to
decrease it press LEFT/UP. As the set level increases or decreases, the bar will
become either longer or shorter to display the current setting. Once you have reached
the desired level, press ENTER to confirm and exit the preset menu.
Note that the set value is always saved. Therefore if you press ESC or if the timeout
time elapses without pressing any key, the power will remain on the last set value.
If you press ESC while you are in the preset menu, the following
selection screen
will be displayed, from which you can access all the other menus:
To enter one of the submenus, select the name (which will be underlined by a flashing
cursor) with the LEFT or RIGHT keys and press ENTER.
If, on the other hand, you wish to return to the preset menu, simply press ESC again.
Fig. 5.1 shows the complete set of machine menus.