TEX1000-LCD
1 / 38
User Manual
Rev. 1.1 - 23/06/05
1. Preliminary Instructions
This manual is written as a general guide for those having previous
knowledge and experience with this kind of equipment, well conscious
of the risks connected with the operation of electrical equipment.
It is not intended to contain a complete statement of all
safety rules which should be observed by personnel in
using this or other electronic equipment.
The installation, use and maintenance of this piece of
equipment involve risks both for the personnel performing
them and for the device itself, that shall be used only by
trained personnel.
R.V.R. Elettronica SpA
doesn’t assume responsibility for
injury or damage resulting from improper procedures or
practices by untrained/unqualified personnel in the handling
of this unit.
Please observe all local codes and fire protection standards
in the operations of this unit.
WARNING:
always disconnect power before
opening covers or removing any part of this unit.
Please observe all local codes and fire protection standards
in the operations of this unit.
WARNING:
this device can irradiate radio
frequency waves, and if it’s not installed following
the instructions contained in the manual and local
regulations it could generate interferences in radio
communications.
This is a "CLASS A" equipment. In a residential place this
equipment can cause hash. In this case can be requested
to user to take the necessary measures.
R.V.R. Elettronica SpA
reserves the right to modify the
design and/or the technical specifications of the product
and this manual without notice.
2. Warranty
Any product of
R.V.R. Elettronica
is covered by a 24
(twenty-four) month warranty.
For components like tubes for power amplifiers, the
original manufacturer’s warranty applies.
R.V.R. Elettronica SpA
extends to the original end-user
purchaser all manufacturers warranties which are
transferrable and all claims are to be made directly to
R.V.R. per indicated procedures.
Warranty shall not include:
1
Re-shipment of the unit to R.V.R. for repair
purposes;
2
Any unauthorized repair/modification;
3
Incidental/consequential damages as a result
of any defect;
4
Nominal non-incidental defects;
5
Re-shipment costs or insurance of the unit or
replacement units/parts.
Any damage to the goods must be reported to the carrier in
writing on the shipment receipt.
Any discrepancy or damage discovered subsequent to
delivery, shall be reported to
R.V.R. Elettronica
within
5
(five) days from delivery date.
To claim your rights under this warranty, you shold follow
this procedure:
1
Contact the dealer or distributor where you
purchased the unit. Describe the problem and,
so that a possible easy solution can be
detected.
Dealers and Distributors are supplied with all the information
about problems that may occur and usually they can repair
the unit quicker than what the manufacturer could do. Very
often installing errors are discovered by dealers.
2
If your dealer cannot help you, contact
R.V.R.
Elettronica
and explain the problem. If it is
decided to return the unit to the factory,
R.V.R. Elettronica
will mail you a regular
authorization with all the necessary
instructions to send back the goods;
3
When you receive the authorization, you can
return the unit. Pack
it carefully for the
shipment, preferably using the original packing
and seal the package perfectly. The customer
always assumes the risks of loss (i.e., R.V.R.
is never responsible for damage or loss), until
the package reaches R.V.R. premises. For
this reason, we suggest you to insure the
goods for the whole value. Shipment must be
effected C.I.F. (PREPAID) to the address
specified by R.V.R.’s service manager on the
authorization
DO NOT RETURN UNITS WITHOUT OUR
AUTHORIZATION AS THEY WILL BE REFUSED
4
Be sure to enclose a written technical report
where mention all the problems found and a
copy of your original invoice establishing the
starting date of the warranty.
Replacement and warranty parts may be ordered from the
following address. Be sure to include the equipment model
and serial number as well as part description and part
number.
R.V.R. Elettronica SpA
Via del Fonditore, 2/2c
40138 BOLOGNA
ITALY
Tel. +39 051 6010506
3. First Aid
The personnel employed in the installation, use and
maintenance of the device, shall be familiar with theory
and practice of first aid.
3.1
Treatment of electrical shocks
3.1.1
If the victim is not responsive
Follow the A-B-C's of basic life support.
•
Place victim flat on his backon a hard surface.
•
Open airway: lift up neck, push forehead back
(
Figure 1
).
Figure 1
