TEX1000-LCD
32 / 38
User Manual
Rev. 1.1 - 23/06/05
WARNING: the SIM card can shown the demand for the PIN code, this cause a fault
in the normally operation of the Modem. Verify to remove this protection with the
support of a common mobile phone.
In order to correctly shape the connect to a
TEX1000-LCD
follow carefully the
following instructions:
1) If necessary, switch off the
TEX1000-LCD
using the switch placed on the front
panel, the FNC menu setting the “Pwr” value in “Off” position, or disconnecting
the equipment from the mains power.
2) Extract the SIM-container from the “GSM SLOT-IN” lodging, placed on the rear
panel, pressing on the indicated points.
3) Put the SIM on the SIM-container. Verify that the cut angle is placed to block itself
inside the SIM-container, this to try to do that the gilt contacts are turns in the right
direction once inserted the SIM inside the machine.
4) Insert the SIM card inside the
TEX1000-LCD
.
5) Connect the RS232 cable (DB9) between the
TEX1000-LCD
and the PC.
6) Connect to the "GSM ANT" (SMA) connector of the
TEX1000-LCD
GSM modem
antenna. Use one directive wideband antenna like the Yagi antenna (700- 900
MHz).
7) Switch on the
TEX1000-LCD
using the switch place on frontal panel, the FNC
menu setting the “Pwr” value in “On” position, or connecting the equipment to the
mains power.
8) Program the inner EEPROM through the use of “TELECON” software.
10.3 Alarms Telesignalling configuration
As first operation is necessary to set up correctly some parameter in the
TEX1000-
LCD
through "TELECON" software. Connect, therefore, through a standard serial
cable (DB9 Male - DB9 Female) the COM serial port of the PC with the RS232
connector present on the rear panel of the
TEX1000-LCD
.
