22
Welding in TIG mode - No remote foot pedal
1
Connect the TIG torch and earth lead to machine & work piece.
2
Connect Argon gas and set flow to approx. 8 LPM
3
Set the machine mode to TIG (No. 7 front panel)
4
Select 2T or 4T torch operation. (No. 15 front panel)
5
Select HF start in TIG start section (No. 19 front panel), if working on vehicles change mode to Lift start, you will need
to touch tungsten onto workpiece and then lift up tungsten slightly to start the arc.
6
Use the forward and back buttons (No. 9 & 10 front panel) to select any parameters you wish to change then use the
control knob to adjust as required (No. 18 front panel)
The relative LED will light up on selected parameter and settings will show in display 1 & 2
Pre-Flow Gas time – Normally set low, for stainless steel this can be raised to purge before welding.
Up-Slope time – When arc is started it will go from minimum amps to main amps over this time
Main welding amperage – Set to 30-35 amps per mm..
Down-Slope time - When weld is stopped it will go from main amps to minimum amps over this time
Post-Flow Gas time - Set Gas post flow to 6 - 10 Seconds, higher amperage requires more post flow.
7
Press the TIG torch switch to start welding
