10
The 4T function in TIG mode acts similarly, but in conjunction with the up/down slope timer. As the torch trigger is
pressed for the second time, the trigger should be held in until the downslope timer completes its cycle. The trigger
may then be released to end the arc. Releasing before the down slope is finished will terminate the arc immediately.
PEDAL is for using the optional remote foot pedal to control TIG amps when welding.
SPOOL is for using the option Spool-on MIG gun. Please note when using spool gun, the wire speed is not controlled
by knob on spool gun, it is controlled from the front panel
16)
Wire type selector
Select your wire type according to the basic categories of Steel, S.S (Stainless Steel) or AL(Aluminum). This
input must be made to properly use the Synergic function to automatically adjust the Volts needed to weld at the
selected wire speed.
17)
Wire Diameter Selector
Select your wire diameter according of the type wire you are using. Selecting the correct wire diameter is critical to
optimum Synergic function of the welder, automatically compensating the voltage while the wire speed is adjusted.
For alternate full manual control of the welder to function in “normal” MIG mode, select STD. This will allow for full,
independent control of MIG wire speed and voltage.
18)
Welding parameter adjustment knob.
When cycling through the various welding settings available, when you have highlighted the parameter you require
using the forward/back buttons (9,10) use this knob to adjust setting which will be shown in display 1 or 2.
19)
TIG Start - HF or Lift start selector
Select HF start for automatic TIG arc starting, press trigger with tungsten away from workpiece and arc will start.
Select Lift Start if working on vehicles etc. with sensitive electronics, press trigger and touch tungsten on workpiece
then lift and arc will start.
