19
Welding in MIG SYN (Synergic) Mode
1
Connect the MIG Torch to machine, connect earth lead to machine & work piece.
2
Fit wire reel to machine using guide on page 15
3
Connect welding gas and set flow to approx. 12-14 LPM
4
Set the machine mode to MIG SYN (No. 7 front panel)
5
Select 2T or 4T torch operation. (No. 15 front panel)
6
Use the forward and back buttons (No. 9 & 10 front panel) to select any parameters you wish to change then use the
control knob to adjust as required (No. 18 front panel)
Wire type – select either Steel, Stainless Steel or Aluminium wire (No. 16 front panel)
For Steel you will require a mixed Co2/Argon gas
For Aluminium welding you will require 100% pure argon gas.
Pre-flow gas - Set at 0.1s for most jobs, if longer gas purge is required set accordingly.
MIG volts - adjust with control knob (No. 18 front panel) and speed will be shown in display 1
In synergic mode, when you adjust voltage the wire feed speed will automatically adjust.
Post flow gas – For most MIG welding along post flow gas is not required.
MIG burn back – This is time power/gas stays on after trigger released – this will burn wire back towards tip.
MIG inductance – low setting softer arc with low splatter , high setting harsher arc with deeper penetration.
We suggest setting in middle for most jobs.
Welding operation
Once you have set the machine up as per above instructions press the torch trigger to start welding, gas will flow from the torch
and main welding power and wire feed will start, once wire has touched work piece welding will start, to stop welding release
torch trigger.
In synergic mode you can trim the wire speed to give the desired weld.
The machine automatically presets wire feed speed to voltage and wire type / diameter selected, sometimes this will need fine
