Connections for IMIG 160
Setup machine as per two diagrams below:
Fig 1 Fig 2
1.
Earth / Workpiece connector
Connect the earth lead (negative -) to this connector.
Insert male connector into socket and twist clockwise until tight. Secure other end of
earth lead to Workpiece via the earth clamp.
2.
Euro torch connector
Connect Euro type MIG torch to euro torch connector, align torch
connector to machine connector and then turn retaining ring clockwise to secure.
Ensure torch is secured tightly to avoid weld power problems To avoid electric shock
keep the MIG torch in good condition and replace if any of the insulation is damaged.
3.
Mains input cable
Fit required plug as per your electrical installation
4.
Gas inlet connection
Connect gas hose to rear of machine and then to regulator on gas
bottle. Ensure all connections are tight to ensure no loss of gas. Make sure gas bottle is
secured to machine securely using supplied chain to avoid injury.
5.
On/Off Power Switch
This turns the
IMIG 160
MIG Welder on and off.
6,
Gas(+)/no gas(-) plug
: gas style connect with “+”socket and no gas style connect with “-
“socket.
7,
Spool gun socket:
When use spool gun function, connect spool gun control plug(7pins)
with this socket and spool gun main cable connect with euro torch socket.