Wire Spool Fitment
1. Wire reel retainer
Push and twist in, to retain wire roll adaptor onto wire reel
2. Roller tensioner
Do not over tighten wire feed pressure roller as this can cause
premature motor and roller failure. Correct way to adjust tensioner is to slacken off
pressure so that MIG welding wire does not feed, slowly adjust pressure until wire feeds
smoothly, you should be able to stop wire feeding by holding wire and it should slip on
rollers. If you have too little pressure wire will slip when welding causing unwanted
Burnback into tips
3. Wire Feed Drive Assembly
Make sure rollers are correct size for wire diameter selected,
to change roller size release retaining screw, remove roller turn roller around and slide
onto shaft making sure the right size groove is in line with wire and refit retaining screw.
The INV160 comes fitted with a dual roller 0.6mm and 0.8mm
4. Wire reel adaptor
Remove the wire reel retainer and wire reel adaptor, slide on roll of
wire and refit the reel adaptor.