QWICK KURB
®
, INC.
Long Term Installation Manual
MAINTENANCE
Inspect the system periodically. Usually the reboundable Flex Boot will not be damaged
even if the marker/bollard is. An undamaged reboundable Flex Boot may be used again by
removing the damaged part from the Flex Boot, and bolting a new marker/bollard top part
to the Flex Boot. Refer to
Appendix B
on page 34 for instructions on how to replace the
tops.
* The L60 SEPARATOR, L61 Male End, and L62 Female End are coated with a special stain
resistant material. It will last several years under normal road conditions. Over time, dirt
and other debris may accumulate around the curb. Pressure wash or brush away
accumulations of such material for optimum visibility.
Contact
QWICK KURB
®
, INC.
for a quote to refurbish L60 SEPARATOR units.
If water backs up against the L60 SEPARATOR and better drainage is needed, use L61 Male
and L62 Female End units to create additional water channels. At each affected position,
simply replace a one-meter L60 SEPARATOR by facing the downslopes of opposing L61
Male and L62 Female End units toward one another, and separating them by several inches.
On rare occasions, the underlying road base is composed of unstable material, which may
cause the anchor bolts to loosen. Consider re-tightening if the anchoring system has held
successfully for a long time; or consider replacing the anchor with a wider version. You
may also re-position the anchors by re-drilling the SEPARATOR in a different position.
Please contact
QWICK KURB
®
, INC.
for specific instructions.
Phone: 800-324-8734
Fax: 813-645-4856
www.qwickkurb.com
1/21/2016
27
