QWICK KURB
®
, INC.
Long Term Installation Manual
PREPARING THE ROADWAY FOR INSTALLATION
CLEANING THE ROADWAY SURFACE
QWICK KURB
®
is designed for mounting on generally flat asphalt and concrete surfaces. A
long-term installation of the L60 SEPARATOR on gravel, dirt roads, or other loose surfaces
may not be effective. Usually, a stiff broom is adequate to prepare an area free from gravel,
cinders, sand, and other debris.
The L60 SEPARATOR should not be installed on top of reflective pavement markers
(RPMs). Preferably, arrange the alignment of the L60 SEPARATOR to the side of any RPMs
in the installation area, or remove the RPMs if appropriate for the conditions. Remove any
surface mount delineator that is in the L60 SEPARATOR’s intended position. If the surface
is highly irregular, e.g., cobblestones, potholes, etc., or of unstable material which may break
or separate if drilled, such as paving bricks, etc., an alternative to the L60 SEPARATOR in
that position may be necessary.
LINING THE INTENDED PATHWAY
Use a chalk line or string to make an edge line for the L60 SEPARATOR. Often, the existing
painted line is straight enough and in the right location so that no additional lining is
necessary.
The L60 SEPARATOR units are 10 5/8” in width. If you are installing over an existing
center lane line, for example, it is usually preferable to center the L60 SEPARATOR on the
lane line so that the L60 SEPARATOR is evenly distributed between lanes.
Phone: 800-324-8734
Fax: 813-645-4856
www.qwickkurb.com
1/21/2016
12
