QWICK KURB
®
, INC.
Long Term Installation Manual
3.
The Stabilizing Bars (metal flanges) protruding from the sides of the reboundable Flex
Boots are designed to rest tightly on top of the L60 SEPARATOR. Accordingly, do not
be concerned if the Stabilizing Bars scrape the top of the L60 SEPARATOR during
installation.
HELPFUL NOTE: If the Flex Boot resists sliding into the slot, insert a pry bar between the road and the
L60 SEPARATOR unit beneath the slot and raise slightly while tapping the Flex Boot. Raising the L60
SEPARATOR unit at the slot will spread open the slot slightly to allow easer installation of the Flex
Boot.
ALTERNATE METHOD: THE Q640 PANEL PULLER TOOL
For easiest installation, we recommend using the Q640 Panel Puller tool. Marker/bollard
installation is faster and easier. Refer to
Appendix A
on page 31 for a description and
instructions.
SECURING THE MARKER/BOLLARD WITH THE S65 BLACK SECURING ARCS
There are two S65 black Securing Arcs for the Flex Boot of each marker/bollard. Each S65
black Securing Arc has two short hex head screws and one long hex head screw.
NOTE: This section does not apply to the L84 Flat Marker/Bollard. The L84 Flat Marker/Bollard
does not require S65 black Securing Arcs.
IMPORTANT: You must install all 3 screws in each S65 black Securing Arc. Start with the longer
4” screw that installs in the top hole of the S65 black Securing Arc. If you use the short screws first, the
Securing Arc may not be tight enough on top.
The S65 black Securing Arcs serve two purposes: discourages theft and strengthens the
reboundable Flex Boot connection.
Securing the Stabilizing Bars that protrude from the reboundable Flex Boot reduces the
chance of the reboundable Flex Boot popping out of the L60 SEPARATOR’s slot upon a
severe vehicular impact on the marker/bollard.
Phone: 800-324-8734
Fax: 813-645-4856
www.qwickkurb.com
1/21/2016
23
