QWICK KURB
®
, INC.
Long Term Installation Manual
INSTALLING THE MARKERS/BOLLARDS
Consult the project specifications to determine the spacing of the markers/bollards along the
length of the separator. Each L60 SEPARATOR unit can accept a maximum of one marker or
bollard. This equates to a 3.35’ on center spacing of the markers. But often they are spaced
further apart. Spacing of markers/bollards every other SEPARATOR unit equates to a 6.7’
on center spacing, and so on.
NOTE: The L84 Flat Marker/Bollard does not have a Stabilizing Bar.
The marker/bollard is best added after the L60 SEPARATOR is bolted into position on the
roadway**. The reboundable Flex Boot of the marker/bollard has a narrow edge and a tall
edge. The narrow edge of the reboundable Flex Boot of the vertical marker/bollard fits into
the center slot of the one-meter L60 SEPARATOR. Notice that there is a small wedge in the
slot (Fig 6). It is easier to insert the reboundable Flex Boot in the side where the wedge is
located, but inserting from either side is effective.
NARROW SIDE OF THE FLEX
BOOT
WEDGE IN THE
SLOT
Fig 6
** Some installations pre-install a marker/bollard to an L60 SEPARATOR before arriving on the
jobsite. This allows for faster installation and less time in traffic. This method may require greater
transport capacity, however, as an L60 SEPARATOR cannot be palletized with an attached
marker/bollard.
Phone: 800-324-8734
Fax: 813-645-4856
www.qwickkurb.com
1/21/2016
21
