© Copyright Qvis ®. All documentation rights reserved.
68
Figure 5-62
5.6.8
PTZ
Note:
All the operations here are based on PELCO-D protocol. For other protocols, there
might be little differences in the setup.
Cable Connection
Please follow the procedures below to go on cable connection:
1. Connect the dome RS485 port to NVR 485 port.
2. Connect dome video output cable to NVR video input port.
3. Connect power adapter to the dome.
PTZ Setup
The camera video should be in the current screen. Before setup, please check the following
connections are correct:
1. PTZ and decoder connection is right. Decoder address setup is correct.
2. Decoder A (B) line connects with NVR A (B) line.
3. Boot up the NVR, input user name and password.
4. In the main menu, click setting, and then click the Pan/Tilt Control button. The
interface is shown as in Figure 5-63. Here you can set the following items:
5.
Channel:
select the current camera channel.
6.
Protocol:
select corresponding PTZ protocol (such as PELCO-D)
7.
Address
: default address is 1.
8.
Baud rate:
select corresponding baud rate. Default value is 9600.
9.
Data bits:
select corresponding data bits. Default value is 8.
