© Copyright Qvis ®. All documentation rights reserved.
14
Figure 3- 3 General installation 2
Step 4:
Adjust the device chassis into the correct position and pull the cable through the cable exit hole of the
installation surface. Line up the holes on the chassis to the three expansion bolt holes you have drilled out
in Step 1. Take three ST3.0 self-tapping screws and secure them in the three plastic expansion bolts. The
Chassis should now be securely fitted to the installation surface.
Important Notes:
Make the host GND grounded. This improves device reliability. For outside installation, the host GND
must be grounded.
GND of vandal-proof series locates next to its exit hole.
Device grounding screw dimension is M3X0.5 with a valid depth of 5mm.
Figure 3- 4 GND hole
Step 5
Please refer to the Step 3 to put the driver module back onto the chassis
’s metal hooks. Then use the inner
hex wrench to secure the two inner hex screws to the chassis. Then connect the network cable and the
power terminal.
Note
After installation, we usually recommend that you take the three white static protection gaskets from
the accessories bag and insert them to the screw holes on the protection enclosure. This is to
enhance device reliability.
If you want to install Micro SD card, please refer to Chapter 3.3.
Summary of Contents for AMB-VANIR
Page 2: ...i...
