Quonset Microwave QM1014, User Manual

Page: 31 / 81

QM1014 LO Synthesizer Distribution Unit User Manual
1. Command Quick Reference Guide
1.1 Common (*) Commands
Table 4.1: Common (*) Commands Summary
Command Page Description
*CLS 53 Clears the data structures. The SCPI registers are
cleared.
*ESE < NRf > 54 Sets the Standard Event Status Enable Register.
*ESE? 54 Returns the Standard Event Status Enable Register.
*ESR? 55 Returns the contents of the Standard Event Status
Register and then clears it.
*IDN? 56 Returns the identification of the device connected to
the computer (Host).
*OPC 57 Causes the LO Synthesizer Distribution Unit to set the
operation complete bit in the Standard Event Status
Register when all pending operations have completed.
*OPC? 57 Returns the operation complete bit in the Standard
Event Status Register when all pending operations
have completed.
*RCL < NRf > 58 Recalls the settings of the LO Synthesizer Distribution
Unit from the specified register (memory location).
*RST 59 Returns the LO Synthesizer Distribution Unit to its ini-
tial power up state.
*SAV < NRf > 60 Saves the settings of the LO Synthesizer Distribution
Unit to the specified register (memory location).
*SDS < NRf > 61 Saves the default settings of the LO Synthesizer Distri-
bution Unit to the specified register (memory location).
*SRE < NRf > 62 Sets the Service Request Enable register bits.
*SRE? 62 Returns the Service Request Enable register bits.
*STB? 63 Returns the LO Synthesizer Distribution Unit status
byte.
*TST? 64 Performs a self-test and returns the result.
*WAI 65 Causes the LO Synthesizer Distribution Unit to wait
until either all pending commands are complete, the
Device Clear command is received, or the power is
cycled before executing any subsequent commands or
queries.
1.2 FREQuency Subsystem
Quonset Microwave Revision 1.2.1 20