LO Synthesizer Distribution Unit
IEEE 488.2 Command Reference
6.3 *ESE
<
NRf
>
The
*ESE
(Event Status Enable) command sets the Standard Event Status Enable Register. This reg-
ister contains a mask value for the bits to be enabled in the Standard Event Status Register. A
1
in the
enable register enables the corresponding bit in the Status Register, a
0
disables the corresponding bit
in the Status Register. The parameter value when expressed in base 2, represents the bit values of the
Standard Event Status Enable Register. Table 4.8 shows the contents of this register.
Table 4.8:
*ESE bit mapping
Bit
Base 2
Meaning
0
1
Operation Complete
1
2
Request Control (not used)
2
4
Query Error
3
8
Device Dependent Error
4
16
Execution Error
5
32
Command Error
6
64
Not Used
7
128
Power On
Syntax
*
ESE
Space
NRf
?
Allowed Values
The
NRf
parameter can be any integer in the range of 0 to 255.
Query
*ESE?
This query returns the contents of the Standard Event Status Enable Register.
Error Message
If the parameter is not in the recognized format, error
-102, "Syntax error"
occurs.
If the parameter is less than 0 or greater than 255, error
-222, "Data out of range"
occurs.
Quonset Microwave
Revision 1.2.1
54
