Quinton ClubTrack, Service Manual

Page: 91 / 148

steps. If additional pressure is required to keep the belt
moving, replace the belt and deck.
G. Test the Walk Belt Operation
1. With the walk belt speed at maximum, observe the tracking. If
it needs adjustment, refer to Walk Belt Tracking in Chapter 4,
Repair/Replacement and Calibration.
2. With the walk belt speed at 3.0 mph, walk on the treadmill.
3. Grasp the handrail and resist the motion of the walk belt. If
any slippage is detected, refer to Replacing the Tensioner
and/or Adjusting the Walk Belt in Chapter 4. Repair/Replace-
ment and Calibration.
4. Stop the walk belt.
H. Shut Down the Treadmill
Turn the circuit breaker off, disconnect the power cord from the
outlet, and place the treadmill back in service.
Field Test No. 1
)
The following steps must be performed with the treadmill
completely assembled, except as noted.
With the power cord connected to the correct outlet, turn on the
circuit breaker.
A. Test the Controller Displays
ClubTrack
®
, HR ClubTrack™, MedTrack
®
SR60, and
MedTrack
®
CR60
Observe the controller displays during initialization. For the
ClubTrack, ClubTrack with Heart Rate Monitor, MedTrack SR60,
and MedTrack CR60, the normal sequence is:
• Seven segment displays show all 8s (888 8888 888).
• After 3 seconds, all displays go blank.
• Multi display briefly shows configuration code (0.0 CP.-x 0.0).
• Normal display is shown (00 150 00).
If the normal sequence does not occur, refer to the following table
for possible causes:
Field Functional Tests D-6