View number of cycles carried out
Introduction.
The meter presents the number of cycles in multiples of 1000, so the number
displayed must be multiplied by this factor.
This data is recorded in permanent memory, but always in multiples of 1000 cycles.
The number of cycles can only be read when the system is in stand-by, that is, when
the screen displays a flashing horizontal line.
In addition, the mechanical cycles meter must be enabled in Menu 2 (index 18).
The following is an example.
Press the DOWN key and for a few seconds the number that
corresponds to the ‘high’ part of the figure is displayed.
After a few seconds the screen returns to displaying the flashing
line.
Press the UP key and for a few seconds the number that
corresponds to the ‘low’ part of the figure is displayed.
After a few seconds the screen returns to displaying the flashing line.
The two numbers are combined as in the following illustration
Therefore, this unit has completed 437,000 cycles
0 4
C
3 7
C
INVIO
INVIO
04 37 000
HIGH
PART
LOW
PART
MULTIPLY
X 1000
If the buzzer option is enabled, upon reaching the maximum number of cycles the
system will indicate the ‘unit maintenance' status by sounding a 1 second audible
alarm at 1 hour intervals when the door is open.
LATEST NOTIONS
The contacts -0V are in series between them, it is recommended the distribution of
equipments for all the available inputs.
When the contact 9-10 is closed the door will make a partial opening even if the
selector is in close position.
Is very useful to allow opening from the outside even with the automation blocked.
The safety contacts 22,20,19 if not used close to ground through a bridge.
