HIGH CURRENT
Short circuit in motor and/or
malfunctioning power supply electronics
POWER CONSUMPTION
ERROR
Over-consumption of power while
operating.
NO LINE
No power available and/or power supply
fuse interruption.
ENCODER ERROR
No encoder signal. Wire broken and/or
encoder malfunction.
NO BATTERY
No battery installed. Wire broken and/or
battery fuse interruption
FLASH ERROR
Memory problem. Processor malfunction,
must be replaced.
LOW BATTERY
Insufficient battery voltage, battery dead.
BLOCKAGE ON
OPENING
Blockage encountered during opening.
BLOCKAGE ON
CLOSING
Blockage encountered during closing.
BATTERY ERROR
Battery failure, must be replaced.
BATTERY TEST
Indicates when the battery test is being
carried out.
HIGH LINE
Voltage of AC power supply 230 V too
high.
LOW LINE
Voltage of AC power supply 230V too low.
TEST PINCODE
PIN code being checked
PINCODE ERROR
Incorrect PIN code entered
SAFETY ERROR
Safety nc open or not installed correctly
ENGINE X ERROR
IMPEDIMENT
Mechanical impediment to the start of
the
reset
phase. The
c8
will be repeated
continuously
List of messages viewable on the screen
Ÿ
With the door closed at rest position, the screen on the right shows a flashing
horizontal line
Ÿ
When door is moving the screen shows the power distributed by the control unit
Ÿ
In case of alerts or anomalous functioning the screen will display a message from
the following table
Ÿ
View user-programmable parameters
Ÿ
View number of cycles
Display functions on the unit:
