Security code (PIN)
Unlocking password PIN-CODE procedure
When you turn on the card, close to ground at the same time the interior and the
exterior radar ;
The display will show the message:
"Rd"
(read) followed by a beep that signals the
PIN CODE
restore factory default.
Press the INVIO button once and the message '
IP
’ (Insert Pin) will appear on the
screen, and after a moment the letter ‘
A
'-- the first digit of the 4-digit code--will
appear, and a moment later a flashing number '
0
' will be displayed.
At this point, use the 'UP' and 'DOWN' keys to enter the first digit of the PIN code.
Press INVIO to move on to the second digit (letter ‘
B
'), wait until the a flashing
number '
0
' appears on the screen, and as before use the 'UP' and 'DOWN' keys to
enter the second digit of your PIN.
Press INVIO to confirm and enter the remaining digits using the same process
described above.
When the last digit has been confirmed, the screen will display '
tP
' to indicate that
the PIN code is being checked; if the code is correct the attention tone will sound
two short tones and the screen will show the first user-programmable parameter.
If the PIN code was entered incorrectly, the message '
EP
' will be displayed and a
tone will sound for approximately 1 second, then the control unit will automatically
return to standby mode showing the flashing line, and will not allow the
user-programmable parameters to be modified.
The control unit has a timer function so that if no keys are pressed for 10 seconds
while in programming mode, the information entered up to that point will be saved
and the unit will exit the programming mode.
Setting all 4 digits of the PIN to 0 turns off the security code.
The control unit comes with the 4 digit PIN code set to 0; please set a personal
security code to protect the user-programmable settings.
If the PIN code is not required (0000), press INVIO to go directly to the first
user-programmable parameter (Index 1).