Quicksilver 675WE, Owner'S Manual

Page: 43 / 91

31
Quicksilver 675WE — System & Component Overview and Operation
LPG Pipe & Hoses
Your LPG system consists of hoses connecting the LPG tank to the stove. The hoses in the LPG system
must be inspected regularly, at least annually, and replaced if any deterioration is found.
System Leak Test
Prior to the boat leaving the factory, the LPG system is tested for any potential leaks. However,
Quicksilver® recommends that you test the system regularly. Test all connections for leakage by
means of the following:
1. Before each use, close appliance valves; open LPG cylinder valve; allow indicated gauge
pressure to stabilize; close LPG cylinder valve; observe pressure gauge reading near cylinder
valve for three minutes; pressure gauge reading should remain constant if no leak in the
system is present.
IF PRESSURE GAUGE READING FALLS, LEAK IS PRESENT. DO NOT USE LPG
APPLIANCES.
2. Routine observation of bubble leak detector (if fitted on the system).
3. Manual leak testing with foam - producing, soapy water or detergent solutions (with appliance
burner valves closed and cylinder and system valves open); foam - producing solutions for leak
detection on gas installations in accordance with EN 14291 meet these requirements.
If a leak is present, shut off the LPG supply at the main supply valve. Extinguish any open flames
(heaters, stoves, etc.) and do not operate any electric switches. Finally, evacuate the area if possible.
Quicksilver® recommends that any LPG system repairs should be made by your authorized
Quicksilver® dealer.
Do not smoke or use open flame when replacing LPG
cylinders. Close cylinder valves on empty cylinders before
disconnecting for replacement.
Ensure that when the LPG stove is on, avoid contact of
materials to the open flame. Never leave craft unattended
when open flame LPG consuming appliances are in use.
Stove
There is a single burner LPG stove located in the galley. Refer to the stove owner ’ s manual for
specific details on operation. Do not use stove when high angles of rolling or sustained angles of heel
are likely. When using the stove, open the sliding cabin windows and the companionway door make
sure that there is plenty of ventilation throughout the cabin. Also, make sure that the starboard
window curtains are stored in the forward position (not over the stove).
Tank Storage
The LPG tank storage is located under a hatch in the starboard side walk - through. Make sure that
the plastic sealed hatch is in place at all times. This hatch seals the LPG tank from the rest of the
cockpit. The tank must be firmly secured to the boat with the tank in an upright position. Do not
relocate or reposition the tank. Do not obstruct access to the LPG tank in any way. Make sure to
keep valves on empty cylinders closed and disconnected, and keep protective covers, caps or plugs
in place. Do not store spare cylinders in the L
- lounge tub. Only keep spare cylinders in ventilated
housings on open decks or in gas - tight lockers which are vented overboard and intended for storing
LPG tanks. Finally, do not use LPG cylinder housing for storage of any other equipment.
LPG Shutoff Valve
An inline LPG shutoff valve is located behind the upper galley door. Always close fuel supply line
valves and cylinder valve when appliances are not in use. Also, remember to close all valves before
refueling and immediately in an emergency. Finally, be sure appliance valves are closed before
opening cylinder valve.