9
According to the above figure to press [ENTER] and the screen will display the interface as shown on the next page:
Notes:
◆
Before performing this function, make sure to retrieve and record the trouble codes.
◆
After clearing, you should retrieve trouble codes once more or turn ignition on and retrieve codes again.If there are
still some trouble codes in the system, please troubleshoot the code using a factory diagnosis guide, then clear the
code and recheck.
4.2.3 I/M Readiness
I/M refers to Inspection and Maintenance that is legislated by the Government to meet federal clean-air standards. I/M
Readiness indicates whether or not the various emissions-related systems on the vehicle are operating properly and are
ready for Inspection and Maintenance testing.
The purpose of the I/M Readiness Monitor Status is to indicate which of the vehicledescribed in Chapter 2.5), and which
ones have not yet run and completed testing and diagnosis of their designated sections of the vehiclesystem.
The I/M Readiness Monitor Status function also can be used (after repair of a fault has been performed) to confirm that the
repair has been performed correctly, and/or to check for Monitor Run Status.
Select [I/M Readiness] and press [ENTER], the screen will display the interface as shown below:
You can use
[▲
]
[▼
] button to select and press [ENTER], the screen will display the interface as shown below:
You can use [LEFT ] [RIGHT ] button to view other data of vehicle. Press [ENTER] to return to Diagnostic Menu.
N/A means not available on this vehicle, INC means incomplete or not ready, OK means Completed or Monitor Ok.
4.2.4 Data Stream
Press
[▲
] or
[▼
] button to select Data Stream in Main Menu interface and then press [ENTER] button to confirm, the
screen will display the interface as shown below: