Troubleshooting
LF-100 User Guide
40
The Media or Lamination roll might be finished, please
check it. Proceed with cutting?
Problem
Yellow and Green light simultaneously on lamination control board.
Cause
When both the yellow and green LEDs on lamination control panel are on, it would indicate that
either the media or lamination sensor have picked up an error or the sensors may be out of sync
and need to be calibrated.
Fix
To fix this, please refer to the “Yellow and Green LED’s simultaneously on lamination control
board” guide above to resolve.
Error: Load the Media
Cause
You launched the Cutting Manager while the plotter’s lever was down.
Fix
Rise the lever on the plotter, then press the button 2 on control panel and wait until the display
will show “READY” as status. Then press retry on the popup window.
Dongle not found
Cause
The software has been opened while the dongle (the red key) was not plugged to the internal
hub or the USB from the Virgo was not plugged to the PC.
Fix
Plug the dongle to the hub, or the Virgo USB to the PC and click retry.
Can’t load sensors
Cause
Media/Lamination sensors might be not plugged in correctly or turned off.
Summary of Contents for LF-100
Page 8: ...Installation and Setup LF 100 User Guide 8 3 Click Next 4 Click Next...
Page 9: ...Installation and Setup LF 100 User Guide 9 5 Click Next 6 In process...
Page 10: ...Installation and Setup LF 100 User Guide 10 7 Click Next 8 Click Finish 9 Click OK...
Page 30: ...Operation LF 100 User Guide 30 Waste Removing Rewinding Module...
