Operation
LF-100 User Guide
16
8.
When both yellow and green LEDs are flashing it means the system is in error status. The
error occurs when the media roll, lamination roll or both are not loaded, broken or simply
they are run out.
To clear the error it is just necessary to restart the module pushing “On-Off” Button.
Clutch Adjustment
It is important to keep the media and laminating film under tension using the clutch adjustments.
If the tension is too tight, the roller system may be damaged; if the tension is too loose, the
media will not be laminated properly.
Load the Laminated Media Into the Plotter
1.
Pull the laminated media under the tension arm, then pass it between the aluminum
rollers. The guide can be adjusted to prevent the media from shifting.
2.
Put the lever, located in the rear of the plotter, in the down position.
Pull the media through the plotter, keeping the media edge in contact with the alignment
points.
Set both pinch rollers at the media edge.
3.
While holding the media in the aligned position with one hand, lift the handle on the rear
of the plotter with the other to secure the media.
Press button 2 as requested on plotter’s display.
Summary of Contents for LF-100
Page 8: ...Installation and Setup LF 100 User Guide 8 3 Click Next 4 Click Next...
Page 9: ...Installation and Setup LF 100 User Guide 9 5 Click Next 6 In process...
Page 10: ...Installation and Setup LF 100 User Guide 10 7 Click Next 8 Click Finish 9 Click OK...
Page 30: ...Operation LF 100 User Guide 30 Waste Removing Rewinding Module...
