QuickLabel LF-100, User Manual

Page: 35 / 42

LF-100 User Guide 35
4
Troubleshooting
Yellow and Green LED’s Simultaneously on Lamination
Control Board
Problem
Yellow and Green LED’s simultaneously on lamination control board. This will also create the
following error:
Cause
All Virgo Digital Finishing Systems are equipped with two reflective sensors on the lamination
module. One is the media sensor, located right after the first two guide rollers, and the other is
the lamination sensor, mounted between the two black knobs on the rubber roller assembly.
When both the yellow and green LEDs on lamination control panel are on, it would indicate that
either one or both of the sensors have picked up an error and the cause could be due to either
the media or lamination roll has run out or the sensors may be out of sync and needs to be
re-calibrated. The following steps below will show you how to tell when each sensor is in error
mode and how to correct it or help you re-calibrate each sensor if needed.
Media Sensor
The media sensor is used to detect the presence of the media. The LED on this sensor should
always be ON after the media has been loaded properly through all the guides; this would also
indicate that the sensor is in good working condition.
Things to Remember About this Sensor
• If the LED on this sensor is OFF after the media roll has been loaded and both the yellow
and green LEDs on the control panel come on, it could indicate that media ran out and
needs to be changed.
• If after loading the media through the guides and the LED is still OFF or BLINKING with
the yellow and green LEDs on the control panel being on, it would indicate that the sensor
is out of sync and needs to be re-calibrated.