QuickLabel Systems pronto! 482, User Manual

Page: 163 / 256

Pronto! 482/486/682/863 9-11
Cleaning
During the normal operation of the cutter, particles of dust and paper can
accumulate inside the cutter. Remove these particles with a soft brush or a
vacuum.
When cutting through the label material instead of the label gap remains of
adhesive may accumulate on the blades. If operating in backfeed mode, such
remains of adhesive may be deposited on the drive roller as well.
Therefore both, the drive roller and the cutter blades, must be cleaned often.
1 Loosen the screw (1) and remove the cutter from the printer.
2 For cleaning the drive roller open the print head and remove the media
from the printer.
3 For cleaning the circular blade you can turn the axle (3) with a
screwdriver for slotted head screws (slot width 7 mm).
1 Remove all deposits both at the drive roller and the cutter blades with
isopropyl alcohol and a soft cloth.
Warning: Before starting any maintenance, turn the printer OFF and
disconnect the printer from the electrical outlet!
Caution: Risk of injury! The cutter blades are sharp!
Note: With the screw (2) the rotation angle of the circular blade is limited to
120°. If you could not remove all pollutions from the circular blade you can
loosen the screw (2) about 5 mm from the profile to turn the axle (3) 360°.