QuickLabel Systems pronto! 482, User Manual

Page: 134 / 256

8-44 Accessories
In this state the contact between PIN5 and PIN14 is opened.
• PIN6 - XDNB - Printer is not ready
An error has occurred on the printer.
The label print is stopped and the details and type of error can be read
from the printer’s display ('Ribbon out'; 'Paper out'; 'No label'; 'External
Error').
To continue the print job you might have to remove by hand the label
from the peel position. In following open the print head and place the
label material backward so that the next printable label on the silicon liner
will be moved through the label sensor again. Close the print head.
After the external error is corrected, it is possible to press the PAUSE key
to continue the print job. Printing of the next label starts when the signal
XSTART is active.
If the external error occurred while the printer was printing, the label will
be printed again.
A label which was in peel position while the external error occurred will
not be printed again. In that case the signal XESP stays active until the
next label is taken from the peel position or, in case of the last label, until
you press the CANCEL key.
If you press the CANCEL key after the error is corrected the print job will
be canceled and the printer will be reset to its initial state.
The signal XDNB is active if the contact between PIN6 and PIN14 is
opened.
• PIN7 - XEDST - Print of label has started
The printing of a label is indicated with a 20ms pulse.
This signal is active if the contact between PIN7 and PIN14 is opened.
• PIN8 - GND - Ground (0V)
• PIN9 - RXSTART - Reverse line of the signal XSTART
• PIN10 - RXFEH - Reverse line of the signal XFEH
• PIN12 - GND - Ground (0V)
• PIN13 - STA - Start signal is active
In operation mode 1 “Print after label is removed”, do not use the signal
STA