QM-7 SERIES SERVICE MANUAL
PAGE 8.8
JANUARY 2012
SUNRISE MEDICAL
Section 8
3. Re-insert and tighten the bolts securing the
pivot point. (figure 8.8.1)
4. As the pivot point is raised, the recline
actuator and gas strut must be raised an equal
amount. Do this by removing the mounting bolts
(B) to raise the units. (figure 8.8.2)
Note: If the pivot point is raised, it is suggested to replace the back pan with a larger pan to
decrease the gap from the bottom of the back to the seat-pan.
fig. 8.8.1
fig. 8.8.2
2. Use a 7/16" socket and ratchet to remove
the bolts holding pivot point (A). Raise it to the
desired location.(figure 8.8.1)
6. Seat-back depth is adjusted by moving the
mounting brackets to the front or the rear, in the
seat-pan track. (figure 8.9.1)
7. Loosen the two mounting bolts (
C
) and slide
the bracket to the desired location. There are
recessed holes in track for Seat depth as well.
(figure 8.8.3)
Seat-back depth adjustment
C
C
fig. 8.8.3
A
B
B
