QM-7 SERIES SERVICE MANUAL
PAGE 8.6
JANUARY 2012
SUNRISE MEDICAL
Section 8
fig. 8.6.1
3. To make a small angle change to one of four
possible settings, (-4°, 0, 4°, 8°) pull bolt out and
change the position of the front edge bracket.
(figure 8.6.1) Then re-attach the nut and tighten
bolt into place. make sure plastic saddles and
washers are in place behind the bracket.
-4°
0°
4°
8°
Note:
Take care not to lose the saddles, or plastic washers between Bracket and seat rail
while performing the next step.
Seat-Height Adjustment
1 The QM-710 has 4 Seat-height positions.
Use a 6mm Hex Key or 6mm socket to remove a
single threaded bolt (A) on each side and adjust
the seat height. (figure 8.6.2)
Front Bracket Seat height adjustment
2. Once you have the correct seat height re-
insert the threaded bolt. Make sure that the
other front bracket has been adjusted the same
amount before tightening the bolts. (figure 8.6.3)
fig. 8.6.2
fig. 8.6.3
A
Note: Please reference "Seat Height Adjustment Matrix" in Section 9 of this manual for correct
adjustment of both the Front and Rear Brackets.
