QM-7 SERIES SERVICE MANUAL
PAGE 8.7
JANUARY 2012
SUNRISE MEDICAL
Section 8
Rear Bracket Seat height adjustment
1 The adjustment can be done by removing the
rear shroud (See rear shroud removal section 8)
and the Bluetooth module, if present.
The rear bolts are inserted on the inside of
brackets and are adjusted to 1" increments.
(figure 8.7.1)
2. Once you have the correct seat height, on
both sides, re-insert the threaded bolt and
tighten (figure 8.7.2)
fig. 8.7.1
fig. 8.7.2
Recline - Adjustments and Procedures
Pivot point adjustment
1 The pivot point (seat/back height) may be
moved up in the seat/back bracket. The factory
setting is 4" measured from the top of the seat-
pan to the pivot point. This may be adjusted up
in 3/4" increments (figure 8.7.3)
Seat-back Angle adjustment
1 The upright seat-back angle is set by the
programming. To adjust the upright Seat-back
angle, request a programming file from Sunrise
Technical Services. No mechanical procedures
are required.
fig. 8.7.3
Note: If the pivot point is raised, the gas strut and Recline actuator must be raised an equal
amount, refer to step 4.
