112786 Rev. F
21
E NG LI S H
IX. DEALER SERVICE AND ADJUSTMENT
J. ANTI-FLUTTER KIT INSTALLATION
1. Remove fork assembly from chair. This may or may not require the removal of the caster
wheel.
2. Insert anti-flutter bushing (A) into the slot (B) at the rear of the fork ensuring the tab goes
between the ends of the snap ring and between the bearings.
3. Install clamp (C) over the top of the fork assembly inserting the inside tab (D) in the front
slot (E).
4. Gently flex the clamp tabs (F) apart to allow it to slide over the recently installed bushing (A).
5. Squeeze the tabs (F) back together and install the sockety head cap screw (G) into the clamp,
insure threads are properly aligned and lightly tighten using a 3mm hex key.
K. FOOTREST HEIGHT ADJUSTMENT
WARNING
The footrest is an integral part of the frame. Chair should not be ridden
without a footrest.
To adjust the height of your footrest, loosen the screw (H) on both footrest clamps. Slide the
footrest up or down to the new desired height and tighten the two set screws. Use a MAX torque
setting of 62 in-lbs (7 Nm). (Frame damage may occur if overtightened.) It is recommended that you
maintain a minimum of 2.0 inches (5 cm) between the lowest point on the footrest and the floor (I).
This will provide adequate clearance for uneven surfaces and prevent damage to your footrest.
Flip-up Footrest
To adjust the angle of the Flip-up Footrest, loosen two bolts (J) and rotate the footrest angle stop
bracket. Once positioned, retighten bolts (J) to 92 in-lbs. For certain narrow widths, only one bolt
will be present.
High Mount Footrest Mount
1. Loosen all four socket heads (K) on both sides of the chair.
2. Slide footrest to desired height.
3. Tighten socket to 62 in-lbs on both sides.
39
38
37
36
38
39
35
34
33
36
37
38
39
Rear of Fork
33
BACK OF FORK
34
35
Rear of Fork
A
B
C
D
E
F
I
G
H
J
A
F
K
