Thank you for choosing an Ego® caravan mover. This has been produced according to very high standards and has
undergone careful quality control procedures. Simply by using the remote control you can move your caravan effortlessly
into any position required within operating guidelines.
Before proceeding with installation and starting to use the mover, please read this manual very carefully and be aware of
all the safety instructions! The owner of the caravan will always be responsible for correct use. Keep this manual inside
your caravan for future reference.
This User Manual covers two models of Ego® Caravan Mover: Model No. PECM01 and Model No. ECM01; any
installation or operational differences between the two models are detailed where appropriate. The caravan mover
consists of two 12V motor-powered rollers, a 12V electronic control box and a remote control. To function, the motor-
powered rollers must be engaged against the tyres of your caravan. The supplied cross actuation device enables you to
engage both rollers at the same time from one side of your caravan. Once this is done the mover is ready for operation.
The remote control will allow you to move your caravan in any direction.
Introduction
Installation Safety Guidelines
These symbols identifiy important safety precautions.
They mean CAUTION! WARNING! SAFETY FIRST! IMPORTANT INFORMATION!
Important Safety Instructions
Read this User Manual carefully before installation and use. Failure to comply with
these rules could result in serious injury or damage to property.
Before starting installation under the caravan:
DO check that the caravan is disconnected from the battery supply and the mains electrical supply.
DO only use adapters and accessories that are supplied or recommended by the manufacturer.
DO check that the tyres are not over worn (fitting to new or nearly new tyres is the best option).
DO make sure that the tyre-pressures are correct to the manufacturer’s recommendation.
DO make sure the chassis is in good condition without any damage and is free from rust, dirt etc.
DO stop work immediately if you are in doubt about the assembly or any procedures and consult one of our engineers
DO locate the battery isolation switch to be accessible at all times when parking and moving the caravan.
DO NOT remove, change or alter any parts of the chassis, axle, suspension or brake mechanism.
DO NOT operate the unit if you are under the influence of drugs, alcohol or medication that could impair your ability to
use the equipment safely.
Installation - Electrical/Electronic Components
Make sure the 12V supply from the battery and any 230V electricity supply are disconnected.
Find a suitable place for the Electronic Control Unit (3), such as a storage area, under a seat or a bed. Make sure this
place is dry and close to the battery (30 cm to 60 cm). The unit can be mounted on the bottom (horizontal) or on the wall
(vertical). When choosing location, ensure that the unit or antenna cannot easily be damaged.
Fix the Electronic Control Unit securely into position with four screws. Note: if the provided screws are not of
suitable length or type for the desired location/material please substitute these as appropriate.
