QUATRO
Air Technologies Inc.
------------------------------------------------------------
We Make Clean Air
----------------------------------------------------------
30 Hymus Boulevard, Montreal, Quebec, H9R 1C9 Tel.: (514) 630-4444 Fax: (514) 630-4454 website:
Normal (Manual) Operation
Manual operation of the unit is accomplished by using the (Red) ON/OFF POWER button.
Variable Digital
Speed Control & “AUTOFLOW”
Speed control is available in all modes of operation (manual & automatic) and is adjusted with the UP & DOWN arrows
located just under the POWER button.
“AUTOFLOW” is an automatic system pressure compensation system. After setting the minimum speed required to
properly evacuate your equipment, the controls will automatically increase the motor speed to compensate for the
increased pressure as a result of filters getting dirty or a system blockage until maximum speed is reached. After a filter
change, system will automatically decrease the speed to the original set point. Please verify that you are achieving
adequate ventilation after a filter change. If not adjust blower speed.
Remote (Automatic) Operation & Remote Status
The Quatro System
is designed to be used with other pieces of equipment that can support remote operation and/or
remote status monitoring. The connection is made using the AE427 QUATRO Universal Remote Cable. QUATRO has
some custom remote cables for specific applications. Contact us for more info on available applications and part numbers.
The Quatro System
supports “Closed Contact” & “1-30V AC or DC” remote operation as well as “Remote Status” signals.
Switching power to control the
QUATRO System
system remotely WILL NOT WORK and can damage the
unit.
Temporary ON Mode
Allows you to temporarily override your automatic remote control of the system
to perform a “quick cleaning” of work
surface. Temporary ON Mode is only available when the Remote/Standby (L5) light is flashing slowly. Use of this mode will
temporarily BLOCK OR DIESNGAGE all other functions.
To initiate:
-
Press POWER (On/Off)
button to start unit, “System ON” LED will FADE In-Out, unit will start.
-
When you finish using this feature, press POWER (On/Off) again. All other functions will be un-blocked.
Operation, Connection & Enabling
Connect the AE427 remote cable in between the Quatro System & the other piece of equipment using only the wires
required as per the diagram below.
