10
11
9. Position the filter housing so that the filter
lines up with the internal thread, ensuring you
have the o-ring installed under the filter thread.
10. Holding the filter by the top rim only (not the
carbon), carefully screw it up into its socket, and
tighten using fingers only.
11. Now refit the filter housing, carefully ensure
the gasket is in place, and hand-tight the stain-
less steel housing.
12. Ideally, you will leave the chlorine in the
chiller unit for a good 15 minutes before flushing
through.
13. When ready, turn off the water supply back
on and run off a few glasses through the chiller
until it clears.
14. Repeat with the water heater and carbon-
ator.
15. A residual taste isn’t a bad thing – it will dis-
appear after a few glasses of water but will
maintain a sanitizing effect.
Distributed by: Global Water Solutions
QT553/CS20 - 07262021
© gws July 2021
Find out more at: www.Quatreau.com
RE-SANITATION AND FILTER CHANGE
