13
You can see that the output of FX2 may be fed back to the input for FX1. This Serial-Feed connection is
located behind the input level adjustment of FX1. So the level of the FX1-input and the level of the serial-
feed can be controlled independently from each other.
Now we start with explanation of FX1: Turn the “PARAMETER/SOUNDGROUP”-dial until you reach
the following sub menu of the edit-menu.:
Edit/Function
<4> Edit FX1
Confirm with the “EDIT/OK”-key and you are at the start menu of effect-editing. In the tables coming up
you find in the first line an explanation of the algorithm and below the parameters that can be edited.
The first 10 algorithms are for reverb-effects. They vary in attenuation, level and repetitions of harmonics and time delay
times to simulate different room sizes. The parameter SFeed of this 10 reverbs are the same:
|1>
Edit\FX1\Typ
|1>\01:Room
here you can choose the type of reverb
<2>
Edit\FX1\Paramtr
<2>\InputLev:\+60
This parameter defines the input level. Take care that at least one part has the
effect send open. Otherwise you will hear no effect-signal.
<3>
Edit\FX1\Paramtr
<3>\SerFeed:\\38
This parameter controls the percentage of FX2 feed back to the input of FX1 (see
graphic on page 12.). This makes it possible to chain the two effect processors.
<4|
Edit\FX1\Paramtr
<4|\Decay:\\\\50
Here the decay-time of the reverb can be controlled
The gated reverb is a reverb that is cut off after an adjustable time.The time when this cut-off shall happen and the
threshold-level at which this gate closes, can be adjusted. This effect is superb for drum- and percussion sounds to simulate
grooving reverbs.
|1>
Edit\FX1\Typ
|1>\11:GatedRev1
Algorithm 11 - 13 offer the gated-reverb effects.
<2>
Edit\FX1\Paramtr
<2>\InputLev:\60
This parameter defines the input level. Take care that at least one part has the
effect send open. Otherwise you will hear no effect-signal.
<3>
Edit\FX1\Paramtr
<3>\SerFeed:\\\0
This parameter controls the percentage of FX2 feed back to the input of FX1 (see
graphic on page 12). This makes it possible to chain the two effect processors.
<4>
Edit\FX1\Paramtr
<4>\TrsHold:\\16
This parameter indicates at which incoming level the reverb will start. If the signal
falls below this level the selected hold-time starts and will cut off the reverb-signal
after the hold period has passed.
<5>
Edit\FX1\Paramtr
<5>\HoldTime:\\2
This parameter is responsible for the duration of reverb after falling below the
threshold-level.
<6>
Edit\FX1\Paramtr
<6>\Attack:\\\16
With the attack-rate the rise-time between closed and opened gate can be selected.
<7>
Edit\FX1\Paramtr
<7>\Release:\\30
Here you can select the closing time of the gate: from immediate to very slow fade
out.
8.) Editing the effects
Reverb-Effekte
Gated-Reverb-
Effekt
QUASIMIDI STYLEDRIVE FANSEITE
http://people.freenet.de/styledrive/
