4 48008002-06
INTRODUCTION
Quartz range of fan coil units are a purpose built range of cooling and heating units that are factory wired and tested and suitable
for ceiling or void mounted.
All casings are manufactured from heavy gauge self finished galvanised steel.
The casing has multiple removable access panels to provide easy access to all serviceable components.
All units are thermally and acoustically insulated with a class 0 insulation
The heat exchange coils are suitable for both heating and cooling using low pressure hot water and chilled water.
All units are fitted with drain trays mounted below the coil to collect and drain any condensation produced during normal operation.
Option of factory fit condensation pump.
Option of factory fit Electric Air Heater Elements
EC/DC Fan Motor are fitted as standard.
AC Fan Motors are available as an option.
AC Units are fitted as standard with High performance, low energy, and external rotor motor fans with thermal contactors built into
windings.
AC Speed control of the fan motors is achieved by means of a multitapped auto transformer which is wired to a three speed and
fine adjustment switches.
Supplied with continuous filament media filters with an extended surface that vastly increases the periods between maintenance
and will last up to 6 times as long as a normal filter.
EU2 grade filters are standard with EU3 grade filters are available as an option, with the option of a metal mesh.
Service access to the fan is from the underside via a full width removable access panel.
Note: Where it is necessary to connect additional electrical or hydraulic controls equipment to the unit to provide a
functional product or where controls have been free issued for factory fitting the responsibility for their correct function
and any associated warranties remain the contractors responsibility.
PRODUCT IDENTIFICATION
The identification serial number label can be found on the controls box
and identifies the unit type, part number and the serial number of the unit.
This information should be recorded and quoted in any correspondence between end user and manufacturer.
The identification serial number label can
be found on the controls box
Fig1
